Table of Contents
Advertisement
FrameStart Delay
If this parameter is set to "Enable," the unit will send FrameStart discovery
and delay frames on this DLCI, and will report the state of the remote FSx
unit. It will also send SOS frames when the FRAD/router connected to this
unit goes inactive.
FrameStart Status
If the remote unit is a Verilink FSx product and FrameStart Auto Discovery is
enabled, the FrameStart Status field will show the status of the remote unit.
The status is "Active" if both the local and remote DLCIs are active and the
remote unit answers to the discovery frames sent by this unit. The status is
"SOS" if the remote unit is active but the FRAD/router connected to it is
inactive. The status is "Inactive" in all other cases.
Remote DLCI
If the remote unit is a Verilink FSx product, and FrameStart Auto Discovery
is enabled, this field displays the DLCI number used on the remote end of this
DLCI.
Remote Unit
If the remote unit is a Verilink FSx product, and FrameStart Auto Discovery
is enabled, this field displays the first three digits of the unit ID configured on
the remote end of this DLCI.
Remote IP Address
Displays the IP address of the unit configured on the remote end of this
DLCI.
Round Trip Delay
Specifies the frame size (in bytes) of packets making the round trip.
Round Trip Rate
Specifies the rate (in seconds) at which Round Trip Delay packets are sent.
DLCI Status Table
The bottom portion of the screen shows a table detailing the actual status of this
DLCI and alarm threshold information as follows:
Status
If this DLCI is up, the status will be "Active"; otherwise, the status will be
"Inactive."
Values: Enable, Disable
Default: Enable if Auto Discovery is set to "Yes"; otherwise Disable
Values: Active, Inactive, SOS
Default: Inactive
Values: 16−1023
Default: 0
Values: 000−999
Default: 000
Values: Active, Inactive
Default: Inactive
V T 1 0 0 I n t e r f a c e
4-31
Advertisement
Table of Contents
