Rule Config Screen - Verilink WANsuite 5330 Reference Manual

Figure 4.25 Service Aware Screen

Rule Config Screen

Select from the <Ndx> column to bring up the Rule Config screen (Figure
4.26) to establish Service Aware parameters. To establish a rule, select the
desired rule configuration options, provide the appropriate filter information
where required, and press the "Esc" key.
Figure 4.26 Rule Config Screen
The paragraphs below describe the rule configuration parameters and their
options.
Service Selects the service to which the rule applies.
NOTICE:
If you change the Service parameter, you must press the "Enter" key to
see the appropriate DLCIs.
DLCI Selects the DLCI to which the rule applies.
V T 1 0 0 I n t e r f a c e 4-35