Verilink WANsuite 5330 Reference Manual page 32

Maintenance Reset
Save and Restart
3-4 W A N s u i t e 5 3 3 0
The Unit screen provides the following user-activated buttons:
Button Function
Submit Sets any values that have been changed. The top "Submit"
button sets any unit parameters changed in the upper section of
the screen, and the lower "Submit" button sets the real-time
clock.
Maintenance Reset Resets unit to its default TDM or Packet configuration.
Save and Restart Saves the current configuration and restarts the unit.
Refresh Refreshes data on the current page.
Use this button to access a screen where you can perform a Maintenance
Reset (Figure 3.2). When you click on the arrow in the pull-down menu box
on the screen, you will have the option to perform a TDM, Packet, or Packet
4 reset. When you select one of these options, all previous configurations will
be lost and the unit will be set back to the specified factory default.
Figure 3.2 Maintenance Reset Screen
NOTICE:
Performing a "Maintenance Reset" or a "Save and Restart" will
terminate communications with the unit. A "Refresh" should be
performed after approximately 10 seconds to restore communications.
Use this button to save the current configuration settings and then restart the
unit. Clicking the "Save and Restart" button on the Unit screen will display a
confirmation screen as shown in Figure 3.3 below. Click the "Save and
Restart" button on the confirmation screen to confirm the action.