Save And Restart - Verilink WANsuite 5330 Reference Manual

Save and Restart

Interfaces Screen
Network Screen
4-6 W A N s u i t e 5 3 3 0
NOTICE:
Performing a "Maintenance Reset" or a "Save and Restart" will
terminate communications with the unit. Refresh (by pressing
"Ctrl+U") after approximately 10 seconds to restore communications.
Selecting "Save and Restart" will display a confirmation menu similar to the
Maintenance Reset menu. Select "yes" to save the current configuration
settings and then restart the unit.
The Interfaces screen displays a list of all the unit's available interfaces as
shown in Figure 4.6.
Figure 4.6 Interfaces Screen
From this screen, you may choose from the following: Network, Serial,
Ethernet, or Supervisory. Each of these interfaces is described below.
The Network screen (Figure 4.7) lets you view and make changes to the
Network interface's configuration as described below. In addition, this screen
provides a table that displays the alarm values for the Network interface.