Table of Contents
Advertisement
Log Out
In-band Management
3-48
W A N s u i t e 5 3 3 0
entering the new password in both these fields, click the "Change Password"
button to update and establish the new password.
NOTICE:
Remember that passwords are case-sensitive. When logging on,
password must be entered exactly as it was programmed.
The Log Out screen (Figure 3.38) is used to log the current user off of the
Web server. The Log Out function is only available after user password
protection has been set. You will be automatically logged out of the system
one hour after you logged on using a password to gain access. After this, you
will be required to enter the password to gain write access.
Figure 3.38
Log Out Screen
There are two ways to implement remote in-band management of a
WANsuite 5330 unit. The first is to use the local router to route management
frames (Web browser or SNMP) between the local LAN and the remote unit.
The second is to use the local WANsuite 5330 unit as an independent
gateway.
Use of Connected Local Router
If you choose this method, no configuration is required in the WANsuite
5330s. Local Router A will route Web/SNMP frames from the PC to the
remote WANsuite 5330s. The remote WANsuite 5330 IP address must be set
within the same network as the remote routers B and C LAN network.
Advertisement
Table of Contents
