Verilink WANsuite 5330 Reference Manual page 108

Protocol Encapsulation
Proprietary Traffic
Type
Proprietary Offset
CIR (bps)
Be (bps))
Bc (bps)
Discard Eligible Flag
In Band Management
4-30 W A N s u i t e 5 3 3 0
The unit uses the first three configuration parameters (Protocol Encapsulation,
Proprietary Traffic Type, and Proprietary Offset) to gather statistics. For in-
band management, "RFC 1490" must be the encapsulation method.
This is the type of encapsulation used by the FRAD/router connected to the
unit.
Values: RFC 1490, Proprietary
Default: RFC 1490
When Protocol Encapsulation is set for "Proprietary," the Proprietary Traffic
Type parameter defines which protocol is encapsulated.
Values: IP, IPX, Ethertype, None
Default: None
When Protocol Encapsulation is set for "Proprietary," the Proprietary Offset
parameter defines the number of octets after the frame relay header where the
proprietary traffic type starts.
Values: 0–64
Default: 0
If a Committed Information Rate is configured here, its value will be used
instead of the default CIR of the frame relay service.
Values: 0–64 k
Default: 0
If an Excess Burst Rate is configured here, its value will be used instead of
the default excess burst of the frame relay service.
Values: 0–64 k
Default: 0
If CIR enforcement is configured to "Yes," the unit will throttle the
Committed Burst down to this value when frames are received with the
BECN bit set.
Values: 0–64 k
Default: 0
If this parameter is set to "Yes," and CIR enforcement is also set to "Yes,"
the unit will set the Discard Eligible (DE) bit for frames sent over CIR.
Values: Yes, No
Default: No
If the unit is to be used as a gateway to reach a remote WANsuite 5330
through this DLCI, set this parameter to "Yes," and configure the remote IP
address and Mask in the corresponding endpoint.
Values: Yes, No
Default: No