Set Parameters Menu - High End Systems intellaspot XT-1 User Manual

Set Parameters Menu

The Set Parameters menu lets you configure your
fixture's motion, display, lamp, and data source settings.
To enter the set menu:
1. Press the Menu button to unlock the menu system
or to move back up the system to the top level
menus.
2. Using the left and right arrows on the Center
button, scroll through the top level to
Parameters Menu
select. The screen will display the SET icon in the
screen banner and the first option of the next menu
level.
Factory Default Settings
This option lets you return all factory options to their
default settings or changes the factory options
individually.
An intellaspot XT-1 fixture ships with the following factory default settings:
Pan Tilt Swap =
Disabled
Pan Invert =
Disabled
Data Source =
DMX
If any of the default settings are changed, this menu reverts to the
restores all factory defaults.
To check and reset factory defaults:
1. Navigate to and select the
is the first option in the next Menu level with the current state.
Settings
and indicates that a factory default has been changed.
Off
2. Press the Enter button to select.
3. To reinstate the factory defaults if
Center button to scroll to
restored to their factory default setting.
intellaspot XT-1 User Manual
TM
Set
and press the Enter button to
Tilt Invert =
Disabled
Display Level =
Lamp Strike Mode =
Set Parameters Menu
is displayed, use the up and down arrows on the
Off
and press the Enter button to select. All settings will be
ON
Set Parameters
Menu
DMX [ ]
Factory Default
Factory Default Se
Settings: On
DMX [ ]
Lamp Life Limit =
Data Loss Timeout =
On
LED Level = On
Auto
Off
as shown above.
CHAPTER 3
Menu System
Disabled
Short
option. The option
On
Factory Default
is the default
On
27