Replacing Interchangeable Motor Driver Boards - High End Systems intellaspot XT-1 User Manual

CHAPTER 5
General Maintenance and Troubleshooting

Replacing Interchangeable Motor Driver Boards

The intellaspot XT-1 fixture is designed with two basic types of motor driver boards:
1. Interchangeable 2-phase boards drive the motors for each of the user-configured modules,
and the Focus/Frost/Zoom functions.
2. Interchangeable 3-phase pan and tilt driver boards.
A driver board is interchangeable with other boards of its type. The position of a board's standoffs
and contact screw determine the board addressing.
CAUTION: The fixture will not function correctly if contact screws are
missing from driver boards.
When replacing a board, observe the following warnings.
WARNING! To avoid electrical shock, disconnect power before servicing.
Equipment surfaces may reach temperatures up to 130° C (266° F).
Allow the fixture to cool before handling.
Locating 2-Phase Motor Driver Boards
Four 2-phase boards control the motors for all Color wheels, Soft Edge Flags, Gobo Indexing and
Rotation as well as Zoom, Focus and Iris functions.
Board 1: Animate/Animate Rot/Prism FX/Prism FX Rot
Board 2: Shutter/Cyan/CTO/Soft Edge
Board 3: Shutter/Magenta/Yellow/Color
Board 4: Gobo 1, Gobo 1 Rotation/Gobo 2/Gobo 2 Rotation
Board 8: Focus/Zoom/Iris
64
8
1
2
intellaspot
4
3
XT-1 User Manual
TM