Setting A Start Channel In Battery Mode - High End Systems intellaspot XT-1 User Manual

CHAPTER 2
Setup and Configuration

Setting a Start Channel in Battery Mode

Note: This option only applies when no power is
applied to the fixture.
1. Turn on the menu system by pressing and holding
the MENU and ENTER buttons at the same time. The
display will show
with the start channel currently assigned to the
fixture and the current versions for fixture and
display software.
2. Use the UP and DOWN arrow buttons on the
Navigation button
to select a valid DMX start channel from 1-474. The display will flash a new option ready for
selection.
3. Press the ENTER button to accept the new DMX Start channel. The display will stop flashing
when a new option is entered. The new address will not be stored until the ENTER button is
pressed.
Setting a Start Channel in Normal Mode
1. After powering on the fixture, unlock the menu by
pressing and holding down the MENU button until
the extended 2-line display appears.
is the first option at the top menu level.
Menu
2. Press the ENTER button to select. The display will
show
Set DMX Start Channel:###
channel that is currently assigned to the fixture.
3. Use the UP and DOWN arrow buttons on the
Navigation button to select a valid DMX start
channel from 1-474. The display will flash a new option ready for selection.
4. Press the ENTER button to accept the new DMX Start channel. The display will stop flashing
when a new option is entered. The new address will not be stored until the ENTER button is
pressed.
14
Set DMX Start Channel: ###
DMX Address
with the start
Set DMX Start
Channel: 001
S/W: v1.3.235
Display: v1.1.0
Set DMX Start
Channel: 000
intellaspot XT-1 User Manual
TM