Mounting The Fixture - High End Systems intellaspot XT-1 User Manual

Mounting the Fixture

You can mount your intellaspot XT-1 fixture suspended from a support system (such as a truss)
or freestanding on its base.
WARNING!
Equipment suitable for dry locations only. Do not expose this
equipment to rain or moisture.
CAUTION!
intellaspot XT-1 fixtures must be installed and operated by trained
personnel only.
Always use a secondary safety cable when mounting this fixture.
Do not mount within 2 meters (6.56 feet) of a flammable object.
Note: Due to the wide variety of possible lighting designs, High End Systems
cannot make specific mounting recommendations. Consider the following
procedure as a suggested guideline only.
Mounting the Fixture Upright
CAUTION!
Do not mount the fixture upright without the four rubber feet
attached.
To mount the fixture upright:
1. Place the fixture on a sturdy, stable non-flammable surface that will support more than the
52.2 kg (115 lb) weight of the intellaspot XT-1 fixture. If the surface is above floor height,
use safety cables to secure the fixture to the surface.
2. Disengage Pan and Tilt locks before powering up the fixture.
intellaspot XT-1 User Manual
TM
CHAPTER 2
Setup and Configuration
9