Copying The Boot Code - High End Systems intellaspot XT-1 User Manual

Copying the Boot Code

When new software is uploaded to intellaspot XT-1 fixtures, it may contain a new boot code which
must be copied to each fixture. This is apparent if the fixture displays a
CAUTION:Do not remove power from the fixture while performing a
To accept and store the new boot code:
1. Navigate to and select the
2. Using the left and right arrows on the Center button, scroll to the
press the Enter button to select.
3. Use the up and down arrows on the Center button to scroll to the
the Enter button to store the command. The fixture will store the new boot code and then
automatically home.
Self Test
This option lets you test the mechanical function of
separate component or all of the components in sequence.
To perform a self test:
1. Navigate to and select the
(see Test Options Menu on page 32).
2. Using the left and right arrows on the Center button,
scroll to the
SELF Test
button to select.
3. Use the up and down arrows on the Center button to scroll to the specific component or to
and press the Enter button to select. The fixture will test the mechanical operation of the
All
selected component. If you selected All, every function is tested in sequence.
Display Test
To start a routine that tests display function:
1. Navigate to and select the
(see Test Options Menu on page 32).
2. Using the left and right arrows on the Center
button, scroll to the
press the Enter button to select.
3. Use the up and down arrows on the Center button
to scroll to and press the Enter button.
On
intellaspot XT-1 User Manual
TM
boot copy.
Test Options Menu
Test Options Menu
option and press the Enter
Test Options Menu
option and
Display Test
BOOTDIFF
, (see Test Options Menu on page 32).
Copy Boot
YES
Self Test:
,
Pan
DMX [ ]
,
Display Test:
Off
DMX [ ]
CHAPTER 3
Menu System
error.
option and
option and then press
33