High End Systems intellaspot XT-1 User Manual page 83

9. Insert the new wedge into the slot
aligning the tab with the clip on the hub.
Note: There are two wedge shapes on the
static color wheel. The wedge type
with an outside tab must always
remain in the position directly
opposite the open position. When
ordering color wedges be sure to
specify whether it should be a
tabbed or a standard shaped wedge.
For dichroic wedge specifications,
see the intellaspot XT-1 support
page at www.highend.com/support/
automated_luminaires/.
10. Slide the module back into the fixture and tighten the thumbscrew screw to secure it.
11. Replace the harness grommet into the slot alongside the module
12. Reattach the bezel and retighten the captive bezel screws.
intellaspot XT-1 User Manual
TM
General Maintenance and Troubleshooting
CHAPTER 5
69