Table of Contents
Advertisement
DMX Start Address
All fixtures must be given a unique DMX starting address when using a DMX control signal, so that the correct fix-
ture responds to the correct received control signals. This DMX start address is the channel number from which
the fixture starts to "listen" to the digital control information sent out from the DMX control source.
Modify the fixture DMX start address on the user interface, located on the upper enclosure. See
Menu Settings
and Programming on page
23.
If you set the same address, all the units will "listen" to the same control signal from the same channel number. In
other words, changing the settings of one channel will affect all the fixtures simultaneously.
If you set a different address, each unit will start to "listen" to the channel number you have set, based on the
quantity of control channels of the unit. That means changing the settings of one channel will affect only the
selected fixture.
In the case of the moving head, which is a 47 channel fixture, you should set the starting address of the first unit
to 1, the second unit to 48 (47+ 1), the third to 95 (48+ 47), and so on.
21
Advertisement
Table of Contents
