Table of Contents
Advertisement
General
The Power Cue Store is suitable for use as a backup to any DMX lighting controller,
storing up to 64 scenes of all 512 DMX channels. Install it as the first device in the
DMX chain after the controller.
Alternatively, it can be used as a stand-alone playback unit, once it has been loaded
from a controller or from a memory card.
The Power Cue Store is designed to be rack mounted. It takes up one rack unit of
space, is 7.3 inches (186 mm) deep, and weighs 7.7 pounds (3.5 kg). The 5-pin XLR
DMX connectors and the mains input are mounted on the rear panel. There is also a
25-pin sub-D connector on the rear panel for optional external control by a 10V/12V
analog controller.
CAUTIONS
(1) Refer servicing to qualified personnel; no user serviceable parts
inside.
À l'intérieur de l'équipement il n'y a pas de pièces remplaçables par
l' utilisateur. Confiez l'entretien à un personnel qualifié.
Derive el servicio de reparación de este equipo al personal calificado. El
interior no contiene repuestos que puedan ser reparados por el usuario.
(2) This equipment is to be used at 120VAC only. Verify the rating of the
power source before you plug it in. Damage to the equipment could
occur if used at an incorrect rating.
Aviso!
Este Aparato solamente puede ser usado a un maximo de 120VAC. Veri-
ficar el poder del voltage antes de conectarlo. Posible danos
pudieran ocurrir si se usa a otro voltage.
Operating Modes
This section discusses the five operating modes of the Power Cue Store:
o
o
o
o
o
Page 4
Configuration mode
Pass-through mode
Scene loading mode
Manual control mode
External control mode
Power Cue Store
TM
User Manual
Advertisement
Table of Contents
