Shown In Fig - ABB COMMANDER 360 User Manual

This manual is divided into 6 sections which contain all the information needed to install, configure,
commission and operate the COMMANDER 360. Each section is identified clearly by a symbol as

shown in Fig. 1.

Displays and Controls
• Displays and Function Keys
• LED Indication
• Error Messages
Operator Mode (Level 1)
• Single Loop Controller
• Cascade Controllers
Profile Mode
(Levels P, r and t)
• Level P – Profile States
• Level r – Profile Control
• Level t – Profile Program
Set Up Mode (Levels 2 to 5)
8
• Level 2 – Tuning
• Level 3 – Set Points
• Level 4 – Alarm Trip Points
• Level 5 – Valve Setup
Getting
Started
Getting
Started
Shunt Resistors
3 x 100Ω
OVERVIEW
Fig. 1 Overview of Contents
Fig. 2 Foldouts
Panel Clamps
x2
Fig. 3 Accessories
Configuration Mode (Levels 6 to E)
• Level 6 – Basic Configuration
• Level 7 – Input Configuration
• Level 8 – Alarm Configuration
• Level 9 – Set Point Configuration
• Level A – Control Configuration
• Level B – Operator Configuration
• Level C – Output Configuration
• Level D – Serial Communications
• Level E – System Calibration
Installation
• Siting
• Mounting
• Electrical Connections
Table A – Template Application
B – Output Sources
Table C – Digital Sources
D – Analog Sources
CJ Sensor
x2
1