Time Events - ABB COMMANDER 360 User Manual

3.2.6 Time Events – Fig. 3.7
Each state generates a source (
equations etc. in the same way as any other digital signal.
Time event states are provided in addition to program and segment events states and do not affect their operation.
Each segment has an associated '
Vent Raise to
Period Cook
Temp
EV. N t EV. N t
12-- -2--
Purge and Vent (event 1)
Steam (event 2)
Air (event 3)
Water (event 4)
3.2.7 End of Profile State
The end of profile state is a digital source which can be assigned in the same manner as any other digital signal.
The state is set automatically when the program is complete and remains set until a reset signal is received. The
state can be configured to reset via a digital source or to reset automatically after two seconds – see Section 3.4/
Profile Control/ End of Profile Reset Source.
' to ' ') which can be assigned to relays, digital outputs, logic
'tEV. 1 'tEV. 4
' setting which is used to control the Time-event states.
EV. N t
Cook Period
EV. N t
-2-4
Fig 3.7 Time Events
3 PROFILES...
Cook Cool
Time Period
Ext
EV. N t EV. N t
-2-- --34
All events switched off when
program complete
Time
End of
Cycle
29