ABB COMMANDER 360 User Manual page 38

...3 PROFILES
...3.4 Ramp/Soak Profile Control
r. 1 1
INC. S
OFF
r. 1 2
dEC. S
OFF
r. 1 3
t. A dJ
OFF
r. 1 4
r. H . E
NO
r. . 1 5
StP. E
NO
r. 1 6
PG. S L
NO
•1 A digital input becomes active when a volt-free contact is closed or a low TTL signal is applied.
34
•1 Segment Time Increment Source (Current Segment)
The time of the current segment can be increased (by an amount set in the
Segment Time Adjust frame) each time the source is activated. (ie. the
source is leading edge triggered).
See Rear Fold-out/Table D,
Digital Sources.
•1
Segment Time Decrement Source (Current Segment)
The time of the current segment can be decreased (by an amount set in
the Segment Time Adjust frame) each time the source is activated. (ie. the
source is leading edge triggered).
See Rear Fold-out/Table D,
Digital Sources.
Segment Time Adjust Value (Current Segment)
The value set is added to or subtracted from the remaining time of a
running segment via a digital signal or from front panel keys, when in the
Time Remaining in Current Segment
[0.1 to 100.0 or OFF]
The time units are set in the
function is disabled.
Front Panel Run/Hold Enable
–
YES
–
NO
Front Panel Stop Key Enable
–
YES
–
NO
Front Panel Program Select Enable
–
YES
–
NO
Continued...
frame of the
Time Units
Enabled
Disabled
Enabled
Disabled
Operator level program select enabled
Operator level program select disabled
r.11...r.16
Increment Segment Time
Decrement Segment Time
.
Operating Page
frame. If OFF is selected, this