ABB COMMANDER 360 User Manual page 60

...5 CONFIGURATION MODE
... 5.3 Level 7 – Analog Inputs
7. 0 4
EN1. H
1000
7. 0 5
ENI. L
0
7. 0 6
b. S d1
UP
7. 0 7
FLt. 1
0
56
Engineering High (I/P1)
[–999 to 9999]
Note. This parameter defaults to the maximum allowed value when
THC or RTD inputs are selected – see Table 5.1.
THC /RTD Type
Min. Max.
–18 1800
Type B
–100
Type E
Type J
–100
Type K –100
–100
Type L
–200
Type N
–18 1700
Type R & S
Type T
–250
Pt100
–200
Table 5.1 Engineering Limits, THC & RTD Inputs
Engineering Low (I/P1)
[–999 to 9999]
Note. This parameter defaults to the minimum allowed value when
THC or RTD inputs are selected – see Table 5.1.
Broken Sensor Drive (I/P1)
NONE – No action. Actual input values remain valid.
UP – Input driven to the maximum upscale value (999)
dN – Input driven to the minimum downscale value (–999)
In the event of a fault being detected on the input, the input is driven in the
direction selected.
Input Filter Time Constant (I/P1)
The input values are averaged over the time set.
[0 to 60 seconds]
Continued...
°C
Min. Span Min.
710
900 45 –148
900 50 –148
65 –148
1300
900 50 –148
1300 90 –328
320
300 60 –418
600 25 –328
7.04...7.07
°F
Max. Min. Span
0 3272 1278
1652 81
1652 90
2372 117
1652 90
2372 162
0 3092 576
572 108
1112 45