Overview; Shown In Fig - ABB COMMANDER C355 User Manual

OVERVIEW

This manual is divided into 6 sections which contain all the information needed to install, configure,
commission and operate the COMMANDER 350. Each section is identified clearly by a symbol as

shown in Fig. 1.

Displays and Controls
• Displays and Function Keys
• LED Indication
• Error Messages
Operator Mode (Level 1)
• Single Loop Controller
• Motorized Valve Controller
• Auto/Manual &
Backup Stations
• Feedforward Controllers
• Cascade Controllers
• Ratio Station/Controller
Profile Mode
(Levels P, r and t)
• Level P – Profile States
• Level r – Profile Control
• Level t – Profile Program
Getting
Started
Getting
Started
Pull-up Resistors
2 x 100kΩ
Fig. 1 Overview of Contents
Fig. 2 Foldouts
Shunt Resistors
3 x 100Ω
Fig. 3 Accessories
Set Up Mode (Levels 2 to 5)
8
• Level 2 – Tuning
• Level 3 – Set Points
• Level 4 – Alarm Trip Points
• Level 5 – Valve Setup
Configuration Mode (Levels 6 to E)
• Level 6 – Basic Configuration
• Level 7 – Input Configuration
• Level 8 – Alarm Configuration
• Level 9 – Set Point Configuration
• Level A – Control Configuration
• Level B – Operator Configuration
• Level C – Output Configuration
• Level D – Serial Communications
• Level E – System Calibration
Installation
• Siting
• Mounting
• Electrical Connections
Panel Clamps
x2
Tables C – Digital Sources
D – Analog Sources
Tables A – Template
B – Output So
CJ Sensor
x2
1