Table of Contents
Advertisement
8
...4 SET UP MODE
4.3 Level 3 – Set Points
3. 0 0
LEV. 3
SEtP
3. 0 1
LSP1
500
•1
3. 0 2
LSP2
200
•1
3. 0 4
LSP4
400
•2
3. 0 5
S. S Pt
300
•1
Displayed only if a local set point source is selected – see Section 5.5/ Set Point Configuration/ Local/Remote
Set Point Source.
•2
Only displayed if the cascade template is selected
44
Level 3 – Set Points
Note. To select this frame from anywhere in this page, press and
hold the
key for a few seconds.
Local Set Point Value 1
Set the default local set point value
[Within set point high and low limits, in engineering units – see Level 9]
Note. This set point is modified by the profile and is selected
automatically when a profile program is run.
Local Set Point Values 2 to 4
[Within set point high and low limits, in engineering units – see Level 9]
Cascade Slave Set Point Value
Set the slave set point value.
[Within slave set point high and low limits, in engineering units]
Only adjustable in Manual mode.
Continued...
3.00...3.05
Advertisement
Table of Contents
