Level B – Operator Configuration - ABB COMMANDER 360 User Manual

...5 CONFIGURATION MODE
5.7 Level B – Operator Configuration
b. 0 0
LEVb
OPEr
b. 0 1
FP. A M
YES
•1
b. 0 2
LC. d S
NO
b. 0 3
FPAK
YES
b. 0 4
S. A dJ
YES
•1
b. 0 5
r. d 15
NO
•1
b. 0 6
b. d 15
NO
b. 0 7
A. P A5
0
•1 Only displayed if the cascade template is selected.
70
Level B – Operator Configuration
Note. To select this frame from anywhere in this page, press and hold
the key for a few seconds.
Front Panel Auto/Manual Key Enable
YES – Enabled
NO – Disabled
Local / Cascade Display
YES – Slave set point displayed in operator level
NO – Slave set point not displayed in operator level
Front Panel Alarm Acknowledge Enable
YES – Enabled
NO – Disabled
Operator Level Set Point Adjustment Enable
– Enabled
YES
– Disabled
NO
Note. Applies to master and slave set points in cascade mode.
Operator Ratio Display
– Ratio setting for Cascade set point displayed in
YES
operator level.
– Ratio setting for Cascade set point not displayed
NO
in operator level.
Operator Bias Display
YES – Bias setting for Cascade set point displayed in
operator level.
NO – Bias setting for Cascade set point not displayed
in operator level.
Auto-tune Password
Enables access to the auto-tune facility in the operator level.
[0 to 9999 (default 0)]
Continued...
b.00...b.07