I Ntroduction - IEI Technology KINO-CV-KINO-CV-N26001 User Manual

KINO-CV-D25501/N26001 SBC
5.1 Introduction
The BIOS is programmed onto the BIOS chip. The BIOS setup program allows changes to
certain system settings. This chapter outlines the options that can be changed.
5.1.1 Starting Setup
The UEFI BIOS is activated when the computer is turned on. The setup program can be
activated in one of two ways.
1. Press the D
2. Press the D
appears on the screen.
If the message disappears before the D
and try again.
5.1.2 Using Setup
Use the arrow keys to highlight items, press E
PageDown keys to change entries, press F1 for help and press E
keys are shown in.
Key Function
Up arrow Move to the item above
Down arrow Move to the item below
Left arrow Move to the item on the left hand side
Right arrow Move to the item on the right hand side
+ Increase the numeric value or make changes
- Decrease the numeric value or make changes
Page up Move to the next page
Page down Move to the previous page
or F2 key as soon as the system is turned on or
ELETE
or F2 key when the "Press Del to enter SETUP" message
ELETE
0.
or F2 key is pressed, restart the computer
ELETE
to select, use the PageUp and
NTER
to quit. Navigation
SC
Page 69