B.1.1 System Requirement - IEI Technology KINO-CV-KINO-CV-N26001 User Manual

KINO-CV-D25501/N26001 SBC
After completing the five initial setup procedures as described above, users can access
the recovery tool by pressing <F3> while booting up the system. The detailed information
of each function is described in Section B.5.
NOTE:
The initial setup procedures for Linux system are described in
Section B.3.

B.1.1 System Requirement

NOTE:
The recovery CD can only be used with IEI products. The software will
fail to run and a warning message will appear when used on non-IEI
hardware.
To create the system backup, the main storage device must be split into two partitions
(three partitions for Linux). The first partition will be for the operating system, while the
second partition will be invisible to the operating system and contain the backup made by
the one key recovery software.
The partition created for recovery images must be big enough to contain both the factory
default image and the user backup image. The size must be calculated before creating the
Page 103