Lan Connection (Single Connector) - IEI Technology KINO-CV-KINO-CV-N26001 User Manual

4.8.3 LAN Connection (Single Connector)

There are two external RJ-45 LAN connectors. The RJ-45 connectors enable connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.
Step 1: Locate the RJ-45 connectors. The locations of the USB connectors are shown
in Chapter 4.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the KINO-CV-D25501/N26001. See Figure 4-14.
Figure 4-14: LAN Connection
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the on-board RJ-45 connector.
4.8.4 Serial Device Connection
The KINO-CV-D25501/N26001 has two single male DB-9 connectors on the external
peripheral interface panel for a serial device. Follow the steps below to connect a serial
device to the KINO-CV-D25501/N26001.
Page 62
KINO-CV-D25501/N26001 SBC
Step 0: