Jumper Settings - IEI Technology KINO-CV-KINO-CV-N26001 User Manual

KINO-CV-D25501/N26001 SBC

4.5 Jumper Settings

NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Before the KINO-CV-D25501/N26001 is installed in the system, the jumpers must be set
in accordance
KINO-CV-D25501/N26001 are listed in Table 4-1.
Description
AT/ATX mode selection
Clear CMOS
LVDS1 voltage selection
LVDS2 voltage selection
LVDS2 resolution selection
PCIe Mini/mSATA mode selection
Table 4-1: Jumpers
4.5.1 AT/ATX Mode Selection
Jumper Label:
Jumper Type:
Jumper Settings:
with the desired configuration.
JP2
2-pin header
See Table 4-2
The jumpers
Label Type
JP2 2-pin header
JP3 3-pin header
JP4 3-pin header
JP1 3-pin header
SW1 DIP switch
MSATA_SW1 2-pin header
Page 49
on the