Lvds1 Voltage Selection - IEI Technology KINO-CV-KINO-CV-N26001 User Manual

KINO-CV-D25501/N26001 SBC
use the jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip
back to pins 1 and 2.
If the "CMOS Settings Wrong" message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 4-3.
Pin Description
Short 1-2 Keep CMOS Setup (Default)
Short 2-3 Clear CMOS Setup
Table 4-3: Clear CMOS Jumper Settings
Figure 4-4: Clear CMOS Jumper Location

4.5.3 LVDS1 Voltage Selection

Jumper Label:
Jumper Type:
Jumper Settings:
JP4
3-pin header
See Table 4-4
Page 51