Mounting To A Fixture Or Test Stand - sauter FL series Instruction Manual

Ensure that the fixing does nor contact the force gauge case. Ensure that anything
coupled to the gauge is screwed finger-tight only. Excessive torque can damage the
load cell and is not covered by warranty.

6 Mounting to a Fixture or Test Stand

The four M3 thread holes on the rear of the gauge can be used for mounting the
gauge to a SAUTER test stand. 4xM3 screws are included in delivery.
Backside housing and dimensions of the force gauge:
Instruments, starting from FL 5 inclusive FL 1K, have got an integrated measuring
cell: Starting from FL 2K, the measuring cell is external , please find dimensions
down below:
7 Powering on
As shown in Figure 1 the control panel has eight keys.
4
13mm
29mm
13mm
76mm
Stärke
Messzelle:
19mm
51mm
FL-BA-e-1714