sauter FL series Instruction Manual page 9

key has been pressed. The AO will appear in the main display if you activate this
feature.
Figure 5
Use UP and DOWN key to move the cursor. Press the ENTER key to select auto-off
option and return to main menu page.
2) PASS-FAIL
The Pass-Fail feature used to set a defined acceptable maximum and minimum
forces gap for measuring. It is activated by setting the lower level and upper level
forces limit. If the forces value is within the gap level, the display will show message
PASS. Any reading values outside this gap (higher or lower), the display will show
message FAIL. If you activate this feature the PF symbol will be shown on main
display.
To access PASS-FAIL menu, Press UP and DOWN to move the cursor point to
PASS-FAIL and press the ENTER key the display will show the Pass-Fail menu
page. Press ESC key to return to the main menu page.
Figure 6
Use LEFT ARROW keys to move the cursor point to the desired value.
Use UP and DOWN keys to change the value, press and hold to scroll values. Use
RIGHT ARROW key to change the unit. Press ENTER to save the settings and return
to main menu page.
*Pass-Fail feature will automatically be disabled if you set LOWER and UPPER = 0
N.
*LOWER must be less than the UPPER.
Example LOWER LEVEL = 0 N, UPPER LEVEL = 20 N
FL-BA-e-1714 9