Control Modes; One Spectral (Auto Run Mode, Manual Mode); Multiple Spectrals (Master/Slave Control) - SHOWTEC 43560 Manual

Spectral M300 Q4 MKII

Control Modes

There are 4 modes:

One Spectral (Auto Run Mode, Manual Mode)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Spectral is not connected with a DMX cable, it functions as a stand-alone device. Please
see pages 15 and 16 for more information about Auto Run Mode and Manual Mode.

Multiple Spectrals (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-p XLR cable to connect the Spectrals and other devices.
The pins:
04) Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on pages 15 and 16 (Auto run, Manual
Mode). This means you can set your desired operation mode on the master device and all slave
devices will react the same as the master device.
Multiple Spectrals (Master/Slave control)
Ordercode: 43560
• Auto run
• Manual (Static control)
• Master/slave
• DMX-512 (3CH, 3CH, 4CH, 4CH, 5CH, 6CH, 9CH)
1. Earth
2. Signal (-)
3. Signal (+)
9
Fig. 03