Backside; Installation; Set Up And Operation - SHOWTEC 43560 Manual

Spectral M300 Q4 MKII

Backside

Fig. 02
04) LED display + control buttons
05) 3-pin DMX signal connector OUT (5A) and 3-pin DMX signal connector IN (5B)
06) Special Power cable 100-240V with male connector
07) Special Power cable 100-240V with female connector
Note: Connect the two powercables (6 and 7) to provide power to the fixture.

Installation

Remove all packing materials from the Spectral M300 Q4 MKII. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Ordercode: 43560
8