Extron electronics IPL T PCS4 User Manual page 13

im Vertrieb von
LAN port cabling
Configuring the LAN port
www.camboard.de
CAMBOARD Electronics
•
For 10Base-T (10 Mbps) networks, use a Category 3 or better cable.
•
For 100Base-T networks, use a Category 5 cable.
•
Use a straight-through cable to connect to a switch, hub, or router.
•
Use a crossover cable to connect directly to a PC. Wire the connector as
shown in the tables below.
Clip Down
1 2 3 4 5 6 7 8
RJ-45
(for connection to a switch, hub, or router)
connector
Pin
1
2
3
4
5
6
1 2 3 4 5 6 7 8
7
8
Twisted
Pairs
Pin
7&8
1
1&2 3&6 4&5
2
3
4
5
6
7
8
RJ-45 connector wiring
You need to configure the LAN port before using it. You can configure the
settings via either SIS commands or the embedded Web pages. See
chapter 4, Web Page-based Setup and Control, or chapter 5, SIS
and Control, for details.
LAN port factory defaults:
•
Link speed and duplex: Auto Detect
•
Unit IP address: 192.168.254.254
•
Subnet Mask: 255.255.0.0
•
Gateway IP address: 0.0.0.0
•
DHCP: Off
UID # label — Contains the unique User ID number (MAC address) of the
5
unit (for example, 00-05-A6-00-00-01). On the PCS4, the MAC address is on
a label in the upper-right corner of the rear panel.
Serial number label — Contains the serial number of your PCS4 unit.
6
Tel. 07131 911201
Fax 07131 911203
Straight-through Cable
End 1 End 2
Wire Color Pin Wire Color
white-orange 1 white-orange
orange 2 orange
white-green 3 white-green
blue 4 blue
white-blue 5 white-blue
green 6 green
white-brown 7 white-brown
brown 8 brown
Crossover Cable
(for direct connection to a PC)
End 1 End 2
Wire Color Pin Wire Color
white-orange 1 white-green
orange 2 green
white-green 3 white-orange
blue 4 blue
white-blue 5 white-blue
green 6 orange
white-brown 7 white-brown
brown 8 brown
ce-info@camboard.de
IPL T PCS4 • Installation and Rear Panel
™
Programming
2-5