Table of Contents
Advertisement
im Vertrieb von
Web Page-Based Setup and Control, cont'd
Monitoring the receptacles and setting the alarm
The Monitor screen on the Configuration tab lets you monitor each receptacle for
any change in its power or its reference threshold condition (full or standby
power). You can also configure the alarm relay and set up the alarm to sound
and/or an e-mail notification to be sent out if any condition at a receptacle
changes.
This screen is updated continually. In addition, you can update it by clicking
Refresh. Refresh also removes any settings that have been entered but have not
been submitted, and returns the entire screen to the settings that were saved
previously.
Monitor screen
To set up receptacle monitoring and configure the alarm, follow these steps:
1.
2.
3.
Monitoring Settings section
In this section, you can specify the following settings for each receptacle by
making selections in the row beside its number.
•
•
•
www.camboard.de
4-16
IPL T PCS4 • Web Page-Based Setup and Control
CAMBOARD Electronics
On the side-bar menu on the Configuration tab, click Monitor.
In the Monitoring Settings and/or Alarm Relay Settings section, enter your
selections (described in the following sections).
When you are finished making selections in one section, click the Submit
button at the bottom of the section to implement your changes. (If you want
to undo all the entries you made in this section, click Cancel instead of
Submit.)
Enable: Select this check box to initiate monitoring of the receptacle. If this
box is not selected, all the other fields in the row are grayed out and you
cannot enter settings for the receptacle.
Condition: From the pull-down menu, select the condition that will be
monitored. Options include receptacle or device power on or off; Full,
Standby, or None power threshold levels; or any change in conditions at
the receptacle.
Send E-mail: Enter an e-mail address to which the PCS4 will send a
preconfigured notification if the selected condition is met.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
Advertisement
Table of Contents
