Table of Contents
Advertisement
im Vertrieb von
Web Page-Based Setup and Control, cont'd
Setting up and configuring the PC using a Web browser
To set up the PCS4 using a Web browser, you must temporarily configure the PC
to communicate with the interface. Then you can change the PCS4's default
settings (IP address, subnet mask, and [optionally] administrator name and
password) in order to use the unit on an intranet (LAN) or on the Internet
(WAN). After you have set up the PCS4 for network communication, you can
reset the PC to its original network configuration.
IPL T PCS4's LAN port defaults:
• PCS4's IP address: 192.168.254.254
• Gateway's IP address: 0.0.0.0
• Subnet mask: 255.255.0.0
• DHCP: Off
• Link speed and duplex level: Auto detected
If you use an existing Ethernet LAN intranet, your network administrator can
provide you with a unique IP address for the PCS4 or confirm whether you need
to set up the PCS4 for DHCP (Dynamic Host Configuration protocol) to have an
address assigned automatically when you sign on.
Setting up the PC for IP communication
Follow these steps to set up communication between your PC and the PCS4. (The
illustrations in this section show screens from Windows 2000. Your screens may
appear slightly different.)
1.
www.camboard.de
4-4
IPL T PCS4 • Web Page-Based Setup and Control
CAMBOARD Electronics
Open the Network Connections page as follows:
Windows 2000:
a.
Locate and right-click My Network
Places on the Windows desktop.
b.
Select Properties.
or
a.
Click the Start menu, and select Settings (if necessary).
b.
From the Start menu, select Control Panel.
c.
On the Control Panel window, double-click Network Connections, then
Dial-up Connections (if necessary).
Windows XP:
a.
From the Start menu, select My Network Places.
b.
From the Network Tasks side-bar menu, select View Network
connections.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
Advertisement
Table of Contents
