Table of Contents
Advertisement
im Vertrieb von
www.camboard.de
CAMBOARD Electronics
ARP-S command screen
After the arp -s command is issued, the PCS4 changes to
the new address and starts responding to ping requests, as
described in the next step.
5.
To verify that the new address has been set, execute a ping command by
entering "ping," followed by the new IP address, at the command prompt.
Ping is a utility or diagnostic tool that tests network connections. It is used
to determine if the host has an operating connection and is able to exchange
information with another host.
Example:
ping 10.13.170.15
The response should be the PCS4's new IP address, as shown below.
Screen showing the Ping command
You can reconnect using either Telnet or a Web browser to verify that the
update was successful.
6.
After verifying that the IP address change was successful, issue the arp -d
command at the DOS prompt to remove the address from the ARP table. For
example:
arp -d 10.13.170.15
Tel. 07131 911201
IPL T PCS4 • Web Page-Based Setup and Control
Fax 07131 911203
ce-info@camboard.de
4-3
Advertisement
Table of Contents
