Renault ALASKAN 2017 Driver's Handbook Manual page 245

When the speed limit is set, the speed limiter sym-
bol and the set speed value
the vehicle information display. The limiter symbol
will turn green.
Changing a speed limit
Use either of the following operations to change an
active speed limit:
•
Push and release the <RES/+> (Resume) switch
j
A upwards or <SET/–> switch
Each time you do this, the set speed will in-
crease or decrease by 1 km/h (1 MPH).
•
Push and hold the <RES/+> (Resume) switch
j
A upwards or <SET/–> switch
The set speed will increase or decrease to the
next multiple of 5 km/h (5 MPH) and then in
steps of 5 km/h (5 MPH).
The new set speed limit value
in the vehicle information display.
When the actual vehicle speed exceeds the set
speed, an audible warning will be heard a short time
after the set speed is exceeded and driver interven-
tion is not detected.
Cancelling a speed limit
To cancel a set speed limit, push the <CANCEL>
switch . The speed limiter symbol
speed value in the vehicle information display
will be turned off.
It is also possible to override the speed limiter by
fully depressing the accelerator pedal beyond the
resistance point.
WARNING
will illuminate in
•
The vehicle may accelerate when the speed
limiter cancels.
•
When additional floor mats are used, be sure
that they are correctly secured and that they
cannot interfere with the accelerator pedal.
Mats not adapted to the vehicle may prevent
proper operation of the speed limiter.
j
B downwards.
Fully depress the accelerator pedal beyond the re-
sistance point. The speed limiter will be suspended
to allow driving above the set speed. The set speed
value will flash and an audible warning will sound.
j
B downwards.
The speed limiter will automatically resume when
the vehicle speed drops below the set speed limit.
Resuming a previous set speed
If a set speed limit has been cancelled, the set speed
will be displayed
will be stored in the speed limiter memory.
This speed limit can be reactivated by pressing the
<RES/+> (Resume) switch
If the current vehicle speed is higher than the previ-
ous set speed, the accelerator pedal will not work
and the set speed value
speed drops below the set speed limit.
When the actual vehicle speed exceeds the set
and the set
speed, an audible warning will be heard a short time
after the set speed is exceeded and driver interven-
tion is not detected.
Turning the speed limiter off
The speed limiter system will be turned off when
one of the following operations is performed:
•
Push the speed limiter main "ON/OFF" switch
speed value
will be turned off.
•
Push the cruise control main "ON/OFF" switch
information will be replaced with the cruise con-
trol information. For details see "Cruise control
(where fitted)" earlier in this section.
•
When the vehicle is stopped and the ignition is
turned to the off position.
Turning off the speed limiter will erase the set
speed limit memory.
Speed limiter malfunction
If the speed limiter malfunctions, the speed limiter
j
symbol
A upwards.
flash.
Turn the speed limiter off by pushing the speed lim-
iter main "ON/OFF" switch
will flash until the vehicle
checked by an approved dealer or qualified work-
shop.
. The speed limiter symbol and the set
in the vehicle information display
. The speed limiter information in the vehicle
in the vehicle information display will
and have the system
Starting and driving
5-43