Cruise Control Operations - Renault ALASKAN 2017 Driver's Handbook Manual

ated. Should this occur, depress the clutch pedal
and turn the cruise control MAIN switch off im-
mediately. Failure to do so may cause engine
damage.
When the cruise control system is on the speed lim-
iter cannot be operated.
The cruise control system operation switches are
located on the steering wheel (right side).
The cruise control system operating condition is
shown in the vehicle information display.
PRECAUTIONS ON CRUISE
CONTROL
•
If the cruise control system malfunctions, it will
cancel automatically. The
(where fitted) indicator in the vehicle information
display will then blink to warn the driver.
•
If the or indicator blinks, turn the
cruise control MAIN switch off and have the sys-
tem checked by an approved dealer or qualified
workshop.
•
The or indicator may blink when
the cruise control MAIN switch is turned ON
while pushing the <RES/+>, <SET/—>, or
<CANCEL> switch. To properly set the cruise
control system, perform the following proce-
dures.
5-40
Starting and driving

CRUISE CONTROL OPERATIONS

Models with speed limiter (where fitted)
<CANCEL> switch
j
A <RES/+> (Resume) switch
or
j
B <SET/—> switch
Cruise control main ON/OFF switch
Speed limiter main ON/OFF switch
(For details, see "Speed limiter (where fitted)"
later in this section) (where fitted)
Cruise control symbol
Set speed value
The cruise control allows driving at speeds above
40 km/h (25 MPH) without keeping your foot on the
accelerator pedal.
The cruise control will automatically be cancelled if
the vehicle speed slows to less than approximately
33 km/h (21 MPH).
Moving the shift lever to the N (Neutral) position
(Automatic Transmission models) or depressing the
NAA1866
clutch pedal (Manual Transmission models) will can-
cel the cruise control.
Turning the cruise control system on
Push the cruise control main switch
control symbol appears together with the last set
speed value (or — — —)
information display.
Setting a cruising speed
1. Accelerate to the desired speed.
2. Push the <SET/—> switch
3. The cruise control symbol
with the set speed value (desired cruising speed)
in the top of the vehicle information display.
4. Take your foot off the accelerator pedal.
The vehicle will maintain the set speed.
If the vehicle speed is less than the minimum set
speed, it will not be possible to set the cruise
NAA1667
control system.
. The cruise
in the top of the vehicle
j
B and release it.
appears together