Child Restraint Installation Using Three-Point Type Seat Belt - Renault ALASKAN 2017 Driver's Handbook Manual

Step 5
5. Test the child restraint before you place the child
in it . Push the child restraint from side to side
and tug it forward to make sure that it is held
securely in place.
6. Check to make sure that the child restraint is
properly secured prior to each use. If the child
restraint is loose, repeat steps 1 through 5.
1-24
Safety — seats, seat belts and supplemental restraint system
CHILD RESTRAINT INSTALLATION
USING THREE-POINT TYPE SEAT
BELT
Installation on rear seats (Double Cab
models)
Front-facing child restraint:
Be sure to follow the manufacturer's instructions for
the proper use of your child restraint. Follow these
NPA1410 steps to install a front-facing child restraint on the
rear seats using three-point type seat belt without
automatic locking mode:
Front-facing: Step 1
1. Position the child restraint on the seat
contact occurs between the child restraint and
the front seat, slide the front seat forward until
contact no longer occurs.
Remove the head restraint to obtain the correct
child restraint fit.
Once removed, store the head restraint in a se-
cure location.
Front-facing: Step 2
2. Route the seat belt tongue through the child re-
straint and insert it into the buckle
hear and feel the latch engage.
3. To prevent slack in the seat belt webbing, it is
necessary to secure the seat belt in place with
locking devices attached to the child restraint.
SSS0758AZ
. If any
Front-facing: Step 4
SSS0493AZ
until you
SSS0647AZ