Glass; Underbody; Wheels; Aluminium Alloy Wheels - Renault ALASKAN 2017 Driver's Handbook Manual

GLASS

Use glass cleaner to remove smoke and dust film
from the glass surfaces. It is normal for glass to
become coated with a film after the vehicle is parked
in the hot sun. Glass cleaner and a soft cloth will
easily remove this film.

UNDERBODY

In areas where road salt is used in the winter, it is
necessary to clean the vehicle's underbody regu-
larly in order to prevent dirt and salt from building up
and causing the acceleration of corrosion on the
underbody and suspension.
Before the winter and again in the spring, the under-
seal must be checked and, if necessary, re-treated.

WHEELS

•
Wash the wheels when washing the vehicle to
maintain their appearance.
•
Clean the inner side of the wheels when the
wheel is changed or the underside of the vehicle
is washed.
•
Do not use abrasive cleaners when washing the
wheels.
•
Inspect wheel rims regularly for dents or corro-
sion. This may cause loss of pressure or damage
the tyre bead.
•
RENAULT recommends that the road wheels be
waxed to protect against road salt in areas where
it is used during winter.

ALUMINIUM ALLOY WHEELS

Wash the wheels regularly with a sponge damp-
ened in a mild soap solution, especially during win-
ter in areas where road salt is used. The salt residue
from road salt could discolour the wheels if it is not
washed off regularly.
CAUTION
Follow the directions below to avoid staining or
discolouring the wheels:
•
Do not use a cleaner that uses strong acid or
alkali contents to clean the wheels.
•
Do not apply wheel cleaners to the wheels
when they are hot. The wheel temperature
should be the same as ambient temperature.
•
Rinse the wheel to completely remove the
cleaner within 15 minutes after the cleaner is
applied.

CHROME PARTS

Clean all chrome parts regularly with a non abrasive
chrome polish to maintain the finish.

CLEANING INTERIOR

Occasionally remove loose dust from the interior
trim, plastic parts and seats using a vacuum cleaner
or soft bristled brush. Wipe the vinyl and leather sur-
faces with a clean, soft cloth dampened in mild soap
solution, then wipe clean with a dry, soft cloth.
Regular care and cleaning is required in order to
maintain the appearance of the leather.
Before using any fabric protector, read the manu-
facturer's recommendations. Some fabric protec-
tors contain chemicals that may stain or bleach the
seat material.
Use a soft cloth dampened only with water to clean
the meter and gauge lens covers.
CAUTION
•
Never use benzene, thinner or any similar ma-
terial.
•
Small dirt particles can be abrasive and dam-
aging to leather surfaces and should be re-
moved promptly. Do not use saddle soap, car
waxes, polishes, oils, cleaning
solvents, detergents or
cleaners as they damage the natural leather
finish.
•
Never use fabric protectors unless recom-
mended by the manufacturer.
•
Do not use glass or plastic cleaner on meter
or gauge lens covers. It may damage the lens
covers.
Appearance and care
fluids,
ammonia-based
7-3