Renault ALASKAN 2017 Driver's Handbook Manual page 144

With the ignition switch in the ON position, push the
<CAMERA> button or move the shift lever to the R
(Reverse) position to operate the 360° Camera. The
monitor displays various views of the position of the
vehicle.
NOTE
At first operation, the corner lines are blinking
yellow for about 3 seconds. This is not a malfunc-
tion but a reminder to be cautious.
Available views:
•
Bird's-eye View
The surrounding view of the vehicle.
•
Front-side View
The view around and ahead of the front passen-
ger's side wheel.
•
Front view
The view to the front of the vehicle.
•
Rear view
The view to the rear of the vehicle.
The system is designed as an aid to the driver in
situations such as slot parking or parallel parking.
4-12
Display screen, heater and air conditioner, and audio system
There are some areas where the system will not
show objects. When in the front or the rear view dis-
play, an object below the bumper or on the ground
may not be viewed . When in the bird's-eye view,
a tall object near the seam of the camera viewing
areas will not appear in the monitor
WARNING
•
The 360° Camera is intended for day time use.
Do not use the system in bad light conditions.
•
The 360° Camera is a convenience feature. It
is not a substitute for proper vehicle opera-
tion because it has areas where objects can-
not be viewed. The four corners of the vehicle
in particular, are blind spots where objects do
not appear in the bird's-eye, front or rear
views. Always look out the windows and check
to be sure that it is safe to move. The driver is
always responsible for safety during parking
and other manoeuvres.
•
Do not use the 360° Camera with the outside
mirror in the stored position, and make sure
that the tailgate is securely closed when op-
erating the vehicle using the 360° Camera.
•
The distance between objects viewed on the
360° Camera differs from the actual distance.
•
The cameras are installed on the front grille,
the outside mirrors and above the rear num-
NAA1864
ber plate. Do not put anything on the cam-
eras.
•
When washing the vehicle with high-pressure
water, be sure not to spray it around the cam-
eras. Otherwise, water may enter the camera
unit causing water condensation on the lens,
a malfunction, fire or an electric shock.
.