4.6
UPS Sidecar Operation – Parallel Redundant Configuration
4.7
Maintaining the UPS Sidecar
4.8
Product Specifications
EATON Powerware
1.
Remove the screw securing the bottom of the UPS Sidecar front panel. Lift up
the panel and remove.
2.
Verify that the UPS Sidecar circuit breakers are set as follows:
Module Output Breaker 1 (MOB 1)
Module Output Breaker 2 (MOB 2)
System Load Breaker (SLB) (if installed)
3.
Reinstall the UPS Sidecar front panel and secure with the screw at the bottom of
the panel.
4.
Start the UPS in Normal mode according to the Multiple Module Parallel
Operation instructions in the operation chapter of the applicable Powerware 9390
installation and operation manual, listed in paragraph 1.5.
The UPS Sidecar maintenance is the same as the UPS. Refer to the applicable
Powerware 9390 installation and operation manual, listed in paragraph 1.5, for
maintenance instructions.
The UPS Sidecar specifications are the same as the UPS. Refer to the applicable
Powerware 9390 installation and operation manual, listed in paragraph 1.5, for product
specifications.
®
9390 UPS Sidecar Installation and Operation Manual
UPS SIDECAR FEATURES, CONTROLS, AND OPERATION
CLOSED
CLOSED
CLOSED
S
164201586 Rev E www.powerware.com
4-15