Table of Contents
Advertisement
Appendix
Screen messages
The battery is very low. The handset should be placed in the
Place
telephone base or charger.
in charger
The answering system has no recording time left.
Rec mem full
The ringer is muted temporarily during an incoming call.
Ringer mute
The entry in caller ID history is now in the directory.
Saved
You have started transferring a call, and need to enter the
Intercom tO:
desired handset number.
(For TL92300)
Unable to call
Failed intercom or conference call (there are already two
handsets being used).
try again
You are trying to make a cell call when the cell line is
Unable to
already being used.
complete call.
Check cellular.
You are trying to save an entry with no name and number
Unable to save
from the caller ID history.
There are new calls in the caller ID history.
XX Missed call(s)
XX New message(s)
There are new messages recorded in the answering system.
75
Appendix
Expand your telephone system
The handsets provided with your telephone system are pre-registered.
Additional handsets registered to the telephone system are assigned
in sequential order. For instance, if you already have HANDSET 1 and
HANDSET 2, the new registered handset is assigned HANDSET 3. This
telephone system accommodates up to 12 handsets.
Add and register a handset (optional)
You can add new handsets (TL90070, purchased separately) to your
telephone system, but each handset must be registered with the telephone
base before use. When first purchased, each expansion handset shows
Press and hold HANDSET LOCATOR on base for 4 sec, then press # on
handset after a battery is installed. You may need to charge the handset
before registering to the telephone base. For more details on battery
charging, see the table on page 8.
To register a handset:
1.
Press and hold
HANDSET LOCATOR on the telephone base for about
four seconds until the red IN USE light turns on.
2.
Press # on the handset. Its screen shows Registering...Please wait and it
takes up to 60 seconds to complete the registration. The handset shows
HANDSET X Registered (X represents the handset number assigned) and
you hear a beep when the registration is completed.
NOTES:
1.
If the registration fails, the handset shows Registration failed for a few seconds and
then Press and hold
HANDSET LOCATOR on base for 4 sec, then press # on
handset. Try the registration process again.
2.
You cannot register a handset if any other system handset is in use.
76
Advertisement
Table of Contents
