Remove A Paired Device; Active Devices - AT&T TL91270 User Manual

Bluetooth
Bluetooth setup

Remove a paired device

If you already have the maximum of four paired devices on the paired devices
list when you want to add another device, you must first delete a paired
device from the paired devices list.
To remove a paired device:
1. Press MENU/ on the handset when it is not in use.
SELECT
2. Press CID or DIR to highlight Bluetooth, then press
/SELECT.
MENU
3. Press CID or DIR to highlight Paired devices, then
press /SELECT.
MENU
4. Press CID or DIR to highlight a selected device when
necessary, then press /SELECT.
MENU
5. Press CID or DIR to highlight Remove paired, then
press /SELECT. The handset displays Remove
MENU
device from paired list? Press SELECT.
6. Press /SELECT to confirm. The handset displays
MENU
Device removed from paired list.
Answering sys
Directory
Cal l log
Intercom
Bluetooth
BLUETOOTH
Add cel lular
Add headset

Active devices

Paired devices
SELECT DEVICE
Headset A
Cel l Phone AC
Connect
Rename
Remove paired
Remove device
from paired
list?
Press SELECT
Device removed
from
paired list
19
Bluetooth
Bluetooth setup
Active devices
Only devices on the active devices list can establish a Bluetooth connection
with the telephone base. Although two paired devices can be connected to
the telephone base, only one Bluetooth cell phone or a headset can be on a
call at a time.
NOTE: When adding, removing, or replacing a Bluetooth device on the active devices list, all
connected devices will be temporarily disconnected until the procedure is complete. It may
take up to two minutes to reconnect.
Review the active devices list
1. Press MENU/ on the handset when it is not
SELECT
in use.
2. Press CID or DIR to highlight Bluetooth, then press
/SELECT.
MENU
3. Press CID or DIR to highlight Active devices, then
press /SELECT.
MENU
Connect/Disconnect an active device
While in the active devices menu, you may connect or
disconnect your active device.
1. Press MENU/ on the handset when it is not
SELECT
in use.
2. Press CID or DIR to highlight Bluetooth, then press
/SELECT.
MENU
3. Press CID or DIR to highlight Active devices, then
press /SELECT.
MENU
4. Press CID or DIR to highlight a device when
necessary, then press /SELECT.
MENU
5. Press CID or DIR to highlight Connect/Disconnect
(whichever is applicable), then press
handset displays Device connected/Device disconnected.
NOTE: When your active device is connected, you will be prompted to select Disconnect.
When your active device is disconnected, you will be prompted to select Connect.
Answering sys
Directory
Cal l log
Intercom
Bluetooth
BLUETOOTH
Download dir
Add cel lular
Add headset
Active devices
SELECT DEVICE
1 Headset A
2 Cel l Phone
Disconnect
Remove active
/SELECT to confirm. The
MENU
20
AC