Table of Contents
Advertisement
Getting started
Installation
You must install and charge
the handset battery before
using the cordless handset.
Install the telephone base close to a telephone jack and a power outlet
not controlled by a wall switch. The telephone base can be placed on a flat
surface or vertically mounted on the wall (page 10). For optimum range and
better reception, place the telephone base in a central and open location.
You may hear interference if your cellular phone is too close to the
telephone base during a CELLULAR call. Make sure that your Bluetooth
enabled cellular phone is between one to 12 feet away from the telephone
base in order to maintain a clear and consistent connection between your
Bluetooth cell phone, telephone base and cell tower.
If you subscribe to high-speed Internet service (digital subscriber line -
DSL) through your telephone line, you must install a DSL filter between the
telephone line cord and the telephone wall jack (page 6). The filter prevents
noise and caller ID problems caused by DSL interference. Please contact your
DSL service provider for more information about DSL filters.
Your product may be shipped with a protective sticker covering the handset
or telephone base display - remove it before use.
For customer service or product information, visit our website at
www.telephones.att.com
or call
1 (866) 288-4268
.
Avoid placing the telephone base too close to:
•
Communication devices such as: television sets, VCRs, or other cordless
telephones.
•
Excessive heat sources.
•
Noise sources such as a window with traffic outside, motors, microwave
ovens, refrigerators, or fluorescent lighting.
•
Excessive dust sources such as a workshop or garage.
•
Excessive moisture.
•
Extremely low temperature.
•
Mechanical vibration or shock such as on top of the washing machine or
work bench.
See pages 8-9 for easy
instructions.
1 (800) 222-3111
. In Canada, dial
5
Getting started
Telephone base installation
If you subscribe to high-speed Internet service (digital subscriber line - DSL)
through your telephone line, you must install a DSL filter between the
telephone line cord and the telephone wall jack. The filter prevents noise and
caller ID problems caused by DSL interference. Please contact your DSL service
provider for more information about DSL filters.
Follow the steps below to install the telephone.
NOTE: The telephone base comes without the wall-mount bracket for tabletop use. If you
want to mount your telephone on a wall, refer to Wall-mount installation on
pages 10-11 for details.
6.
Plug the other end
of the telephone
line cord into a
telephone wall jack.
5.
Plug the large end
of the larger power
adapter into an
electrical outlet not
controlled by a wall
switch.
4.
Raise the antenna.
3.
Route the cords
through the slots.
DSL filter (not included) is
required if you have DSL
high-speed Internet service.
Telephone line cord
1.
Plug one end of
the telephone
line cord into the
telephone jack on
the bottom of the
telephone base.
2.
Plug the small
end of the larger
power adapter
into the power
jack on the
bottom of the
telephone base.
6
Advertisement
Table of Contents
