Battery Installation; Wall-Mount Installation; Tabletop To Wall-Mount Installation - AT&T TL91270 User Manual

Getting started
Battery installation & charging

Battery installation

Install the battery as shown below.
1. Plug the battery 2. Align the cover flat
connector securely against the battery
into the socket inside compartment, then
the handset battery slide it upwards until
compartment, matching it clicks into place.
the color-coded label.
Insert the supplied
battery with the label
THIS SIDE UP facing
up as indicated.
To replace the battery, press the tab and slide
the battery compartment cover downwards. Lift
out the old battery and disconnect it from the
handset. Follow the instructions above to install
and charge the new battery.
IMPORTANT INFORMATION:
Use only the supplied rechargeable battery or replacement battery (model BT166342). To order,
www.telephones.att.com
visit our website at
1 (866) 288-4268
In Canada, dial .
CHARGE light
3. Charge the handset by
placing it face up in
the telephone base or
charger. The CHARGE
light is on when
charging.
1 (800) 222-3111
, or call
9
Getting started

Wall-mount installation

Your telephone base is ready for tabletop use. If you want to mount your
telephone on a wall, use the provided wall bracket to connect with a
standard dual-stud telephone wall-mounting plate. If you do not have this
mounting plate, you can purchase one from many hardware or consumer
electronics retailers. You may need a professional to install the mounting
plate.

Tabletop to wall-mount installation

1. Position the telephone base as shown below. Insert the extended tabs
(marked B) of the wall-mount bracket into the slots on the back of the
telephone base (marked B). Push the telephone base down until it is securely
in place.
2. If you are using a DSL filter, plug the line cord into the filter now. Route
the telephone line cord (or DSL filter) through the wall mount bracket hole.
Route the power cord out of the bottom of the telephone.
3. Plug the telephone line cord (or DSL filter) into the wall jack. Plug the
power adapter into a power outlet not controlled by a wall switch.
4. Align the holes on the bracket with the standard wall plate and slide the
bracket down until it locks securely. Bundle the telephone line cord and
power adapter cord neatly with a twist tie.
.
If you want to mount your
10