Expand Your Telephone System; Add And Register A Handset (Optional) - AT&T TL92271 User Manual

Appendix

Expand your telephone system

Your telephone can support up to 12 cordless handsets. The handset must
be registered to the telephone base before use. You must register each
handset separately.
The handsets provided within your product box are already registered as
HANDSET 1 and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HANDSET 12).

Add and register a handset (optional)

You can add new handsets (TL90071, purchased separately) to your
telephone system, but each handset must be registered with the telephone
base before use. When first purchased, each expansion handset shows
Put handset on BASE to register
should be charged without interruption for at least 30 minutes before
registering to the telephone base. For more details on battery charging, see
the table on page 9.
To register a handset:
1. Make sure the handset shows Put handset on
BASE to register.
2. Put the handset you wish to register on the
telephone base cradle.
3. The handset displays Registering handset...
on the handset and the red IN USE light on
the telephone base turns on. It takes about 90
seconds to complete the registration process.
The handset displays HANDSET X Registered
(X represents the registered handset number).
The IN USE light turns off and the handset
beeps when registration completes.
If registration fails, it will automatically try to register
again. If it fails after the third try, the handset shows
Registration failed, then Put handset on BASE to
register. This may take up to 5 minutes to occur. When
the handset displays Put handset on BASE to register,
please start again from Step 1 above.
NOTES:
• You cannot register a handset if any other system
handset is in use.
• If you try to register more than 12 handsets to the
telephone base, the telephone base shows Registration
slots are full and sounds 2 beeps.
after a battery is installed.
94
Each handset
For registration, put
the handset on the
telephone base, not
the handset charger.