Mounting; Instructions; Ul Rack Mounting Guidelines - Extron electronics HC 404 User Manual

Transmitter and receiver collaboration system

Hide thumbs Also See for HC 404:

Table of Contents

Mounting

Turn off or disconnect all equipment power sources and mount the transmitter and receiver as

required. The transmitter and receiver each ship with furniture mounting brackets attached.

Figure 25.

NOTE: The receiver is designed so that its vents face away from the wall or furniture

The HC 404 product page on

1U high rack shelves or rack mounting kits. An Extron support representative can

recommend which kit to order for your installation. Alternatively, you can remove the pre-

installed furniture mounting brackets and attach four rubber feet at the corners of each unit

and place it on a table or desk.

•

The following Underwriters Laboratories (UL) guidelines pertain to the safe installation of

HC 404 System devices (the HCT 103 and HCR 102) in a rack.

Mounting the Transmitter (Left) and the Receiver (Right)

when mounted in order to achieve optimal air circulation and cooling.

www.extron.com

See the installation guide for the mounting brackets or optional rack shelf for mounting

diagrams and instructions.

Observe local and UL safety guidelines for mounting devices to equipment racks.

Elevated operating ambient temperature — If installed in a closed or multi-unit

rack assembly, the operating ambient temperature of the rack environment may be

greater than room ambient temperature. Therefore, install the units in an environment

compatible with the maximum ambient temperature (Tma = +104 °F, +40 °C) specified

by Extron.

Reduced air flow — Install the equipment in a rack so that the amount of air flow

required for safe operation of the equipment is not compromised.

Mechanical loading — Mount the equipment in the rack so that a hazardous

condition is not achieved due to uneven mechanical loading.

includes links to recommended optional

HC 404 System • Reference Information

Table of Contents