Table of Contents
Advertisement
Network Communication Setup
Network setup is essential before you configure control settings. You can configure basic
network settings in one of the following ways:
•
•
•
Network Configuration via OSD Menu
To configure network settings from the OSD menu:
1.
2.
3.
4.
5.
Via front panel controls and the OSD menu — a quick method to use whether or
not you need to configure other settings. This requires connection to a display device.
Via PCS software — a method that provides basic network configuration and is
convenient when you are ready to use PCS to configure AV settings. This requires a PC,
software, and a LAN or USB connection.
Via Toolbelt software — a method that allows you to configure additional connection
settings and is convenient when you want to configure additional device, password,
system, and control port settings. This requires a PC, software, and a LAN connection.
Connect an HDMI display device to the HDMI/CEC output connector on the HCR 102.
Power on the receiver and the display device, if they are not already powered on.
On the front panel of the receiver, press the Menu button. The on-screen display should
appear on the connected display or in the projected image.
Press the front panel Menu button on the HCR 102 (see
location). The OSD main menu appears on the display.
NOTE: For details on the OSD menu system and its use, see
Menu System
starting on page 28.
Navigate through the menus and make adjustments. For the IP address, either set a
static IP address (with DHCP off) or turn DHCP on to let the DHCP server select the IP
address for the unit.
a.
Press the up and down arrow navigation buttons (see
navigate to and highlight the desired menu or submenu. For network configuration,
select the Quick Setup menu or the Communication menu.
b.
Press the Enter button (see
items for the selected submenu.
c.
Press the up and down arrow buttons to navigate to and highlight submenu
items.
d.
Press the Enter or right arrow button to adjust a submenu item.
From the Quick Setup menu:
DHCP — Select and enter the DHCP Mode submenu and press the arrow buttons
•
to turn DHCP on or off (default: off).
IP address — Select and enter the IP Address submenu. Press the left
•
or right arrow button to move between octets. Press the up and down
arrow buttons to change the value in the selected octet.
Default: 192.168.254.250.
From the Communication menu:
NOTE: Hold the Enter button for 10 seconds to make changes in this submenu.
DHCP — Select and enter the DHCP Mode submenu and press the arrow buttons
•
to turn DHCP on or off (default: off).
G
) or right arrow button to access submenu
HC 404 System • Hardware Features and Installation
figure
2,
F
for button
Using the OSD
figure
2,
H
) to
22
Advertisement
Table of Contents
Troubleshooting
