Front Panel Features; Reset Features; Configuration Connection; Input Selection And Indication Features - Extron electronics HC 404 User Manual

Front Panel Features

HCT 103
HCR 102
R
I J
Figure 2.

Reset Features

J
I

Configuration Connection

A

Input Selection and Indication Features

B
C
D
B
INPUTS
2
INPUT
1
CONFIG
A B
HCT 103 Front Panel (Top) HCR 102 Front Panel (Bottom)
Reset button — Pressing this recessed button (figure 2,
product settings to be reset to the factory defaults.
Reset and power LED— This green LED (see
status of the receiver, or the reset mode. LED indications are as follows:
Off — The HCR 102 is not powered on.
•
On, lit steadily — The HCR 102 is powered on.
•
Blinking — The unit is performing a reset or is powering up. The blink pattern
•
depends on the selected reset mode.
For full descriptions of reset modes, how to use the reset button to activate them, and
details of LED indications of each mode, see
Software on page 41 and the
Configuration (Config) connector —To configure AV settings using Extron PCS
software, connect the USB port of a Windows-based PC or laptop to the HCR 102 via
this USB mini-B connector (see figure 2,
Input selection buttons and LEDs — Press one of these buttons (see
figure 3, ) to select the corresponding input. The corresponding LED lights to
B
indicate that that input is selected (active). LEDs for deselected inputs are off (unlit).
Signal LEDs — These LEDs (see
at the corresponding input connector. If there is no active signal, the LED is unlit.
HDCP LEDs —These LEDs (see
with HDCP encryption at the corresponding input connector. Because input 2 on the
transmitter is analog video, it does not support HDCP, so there is no HDCP LED for
transmitter input 2.
HDCP LED State and Indication
On (Lit Steadily)
An HDCP encrypted TMDS signal is
detected at the corresponding input.
3 4
SIGNAL
C
AUDIO
1
SIGNAL LPCM-2CH
HDCP MULTI-CH
D E
) indicates either the power
I
Resetting the Unit Manually or Via
reset modes table on page 42.
).
A
) light to indicate the presence of an active signal
C
) light to indicate the presence of an active signal
D
An unencrypted TMDS signal is detected
at the corresponding input or no active
TMDS signal is detected.
HC 404 System • Hardware Features and Installation
C
2 3 4
HDCP
HCT 103
D
MENU HOLD FOR 720p/1080p
ENTER HCR 102
FG H
, above) causes various
J
Off (Unlit)
1
8