Table of Contents
Advertisement
6.
Either select (enable) the Use DHCP checkbox to have the receiver obtain an IP
address automatically from a DHCP server, or
enter the static IP address for the unit in the IP Address field.
NOTE: When setting up DHCP during network configuration or if using a host
name instead of an IP address, the user must enter a qualified host name
(Username.HostName.Domain). For example: somename.extron.com.
7.
Configure the other items (device name, subnet mask, gateway address, DNS server
address) as needed.
8.
Click Apply to save the configuration changes. Alternatively, if you accessed this dialog
box from the Device Discovery page, you can click Apply and Connect to save the
configuration changes and then establish a connection from the PCS software to the
receiver to configure AV settings.
Network Configuration via Toolbelt Software
To configure network settings using Toolbelt:
1.
Connect the PC and the LAN port of the HCR 102 receiver to the same network. For
details on the LAN connection, see
2.
Apply power to the PC and the HCR 102.
3.
Open the Toolbelt software from within Global Configurator or open the stand-alone
Toolbelt application. Extron recommends opening Toolbelt as an administrator by right-
clicking the Toolbelt icon and selecting Run as administrator.
4.
Start Device Discovery (click Start Discovery). Toolbelt searches for and displays a
list of all Extron control devices connected to the network as it detects them.
5.
Using the MAC address, locate the desired device (HCR 102) in the list and select it.
6.
Choose one of the following options (see the rightmost column of the device list):
Click the Set IP link (if available). A Set Network Properties dialog box
•
opens.
a.
b.
Click the Manage link and then click the Network Settings tab in the right side
•
of the window.
a.
b.
c.
Configure the IP address, subnet mask, and gateway address as needed.
Click Enter. The system saves the settings and closes the dialog box.
Either select (enable) the Use DHCP checkbox to have the receiver obtain an IP
address automatically from a DHCP server, or enter the static IP address for the
unit in the IP Address field.
NOTE: When setting up DHCP during network configuration or if using a
host name instead of an IP address, the user must enter a qualified host
name (Username.HostName.Domain). For example:
somename.extron.com.
Configure the other items (device or host name, subnet mask, gateway
address, DNS server address) as needed.
Click Apply to save the configuration changes or click Cancel to discard
changes.
HC 404 System • Hardware Features and Installation
LAN (IP) connector and LEDs
on page 18.
25
Advertisement
Table of Contents
Troubleshooting
