Extron electronics HC 404 User Manual page 59

7. Click on the EDID Minder button in the global navigation bar to open the EDID
Minder page.
8.
Assign an EDID (see the EDID Minder topic in the PCS - HC 404 Module Help file), if
required.
9. If needed, return to the Input/Output Configuration page and change the
aspect ratio mode.
10. Click on the Picture Config button to open the Picture Configuration page.
11. Select input 2 in the AV Controls panel, then make any desired image adjustments,
including adjusting horizontal and vertical start locations, total pixels, and pixel phase
within the Signal Sampling pane (see the Picture Configuration topic in the PCS -
HC 404 Module Help file).
12. Click on the Audio Config button to open the Audio Configuration page.
13. Configure the audio input format and the output volume and format (see the Audio
Configuration topic in the PCS - HC 404 Module Help file).
14. Click on the General Settings button to open the General Settings page.
15. If needed, configure additional items:
Set the device name (see "Assigning a device name" in the General Settings topic in
•
the PCS - HC 404 Module Help file).
Set administrator and user passwords. These passwords are used for logging
•
into (controlling access to) the unit and its settings (see "Assigning and changing
passwords" in the General Settings topic). You cannot set a user password unless
an administrator password exists. By default, the admin password is "extron"
Set the executive mode for locking the front panel controls (see "Setting Front Panel
•
Lockout (Exec Mode)" in the General Settings topic).
HC 404 System • Software-based Configuration and Control 51